Hello everyone
I offer 63xx motor mounts with idlers for RKP trucks:
- Boardnamics 220, 270,
- Torque CNC, 220
- Trampa 12 Fifties
The motor plates have the same design as the DKP truck mounts (described here), but have 16 holes for mounting clamps
As with the DKP mounts, 2 lengths are available:
Short - designed for 16/47 gear ratio
Long - designed for 16/66 gear ratio
- 16 is the number of teeth of motor pulley, number of teeth can be smaller
- 47-66 is a number of teeth of the hub pulley, number of teeth can be smaller
Currently available mounting clamps for trucks:
• Boardnamics 220, 270
• Torque 220 CNC,
• Trampa 12 Fifties
It is possible to make mounting clamps for other trucks, but it is required to have a constant cross-section at the place of mounting of the mounting clamp
Here is an example:
Backfire Ranger X1 truck mounts, this board has 2 front BF X1 trucks mounted
This board was made before Backfire offered Hammer 
Standard angle change is 22.5 degrees, for additional angle change you need to invert mounting clamp, then you have intermediate tilt and angle change is every 11.25 degrees
The price of the sets is $100
Set includes:
- Two motor plates (left and right) with idlers,
- Two mounting clamps
- Bolts for mounting the motor plates and the motors
The price of short and long version is the same.
For EU countries, the price will be increased by 23% VAT.
I send packages via Fedex, in Europe in some countries via GLS. Delivery time is a few days.
corrected 
