Not yet he has to produce an adapter
3 Likes
@Fosterqc you beat me to it 
but there’s 3 
we need to make a poll so he will make some 
3 Likes
Fuck, thanks guys.
They looked so perfect too…
2 Likes
Thank god I saved up my paycheck for the past 3 months 
2 Likes
do you plan to build M1 Gear Drive for matrix ll?
Think he said January ish.
2 Likes
Finally purchased some! Thanks for restocking these. Slowly gathering hardware for my build.
4 Likes
Has anyone actually tried crossbars with these mounts? I’m considering some to act as carry handles, but I’m not sure what would work well. Threaded rod? PVC pipe? Wooden dowel?
2 Likes
threaded rods should be good but theses motor mounts are so strong you don’t need , i run a 12s setup and no problem so far
1 Like
Hey @boardnamics, have you considered making matrix II compatible hangers yet?
I can easily but matrix III is probably a better bet.
4 Likes
Do we even know when that container will come out of the ocean?
Plus it could that they are making a precision truck this time, no?
52 posts were split to a new topic: MBS Matrix iii (3) discussion
I bought a mountain board off Amazon and have the trucks just getting Dustin’s I’m not sure what to do with them but they are very light and have a screw hole for something in both sides of one of the trucks very close to the steel axel but in the soft metal part i will attempt to send a pic but idk if it will let me so im trying to describe my trucks as best as I can.what do you think? Will those mounts work with these trucks?
I always do this shit where I’m trying to buy something posted 4 years ago smh
Haha hit up @IDEA and see if he still makes mounts for these.
1 Like
At the moment, I have nothing for these. It is possible to custom make something but it would come at an additional cost.
I got some mounts from ATC creations for these trucks. Pm me
I believe you already doing a gear drive for me I was hoping for something simple while I waited