Me too, but it is still not delivered after 37 days… F… Usps!
Dass a very vague Q… lots of factors go into the torque… save all the time
Use this https://calc.3dservisas.eu/
You can check torque valzz…n shit n u can compares…
It ain’t a vague question. I’m asking for performance of motor.
All his motors list torque in specifications.
Damn. Torque output is 5.06 NM “short for no mames ”
@torqueboards Dexter. Can you post full specifications for the new motors please?
I am assuming some other parameters may have changed with going to 190kV.
Thanks.
Do the TB6380 motors actually run 80.0mm long?
They appear more like 82mm or 81.75 but these are all modified so I can’t measure directly. Maybe someone else can measure
Oof, there goes any hope of using the extended axle 184mm hangars lol
They work great on those hangers, but just one motor per truck
Haha I can’t do single drives, I got the small board and its okay but I loose traction every turn
For this I am thinking Berg rims with the 160x55 tires, BN 220 trucks and idler mounts but with the axles cut and re tapped to be 35mm instead of 50mm, dual 6380 in 190kv because apparently nobody likes torque anymore, and 13T to a custom 72T printed pulley
But to be fair I’ve completely changed those parts about 7 times in 4 days so I can’t say for sure
Awd? Mucho torquezzzzz …
Haha I think an AWD board would have enough kick to dislocate my ankles
AWD TB6380 builder be like
“I pulled the trigger, but now I’m just standing on the street, and the board is 5km away with my shoes on top of it”
Haven’t people successfully run 4x 80100s?
Yes, they have started. Orders should be picked up tomorrow.
Ive got a hunch my 170kv’s are really 180’s since I did 37mph 3/4 of the throttle with a gearing that should only allow 37mph top speed.