I just did a wheel base reduction and chop job for my friend.
Then went Dog skating to test it out!
8 Likes
Confucious say
Dog food cheaper than samsung 30q cells
6 Likes
Shortening the wheel base from 81cm to 76cm drastically improved its carving performance
2 Likes
Dude no one here will try to talk you out of it 
.
If you are taking suggestion, id say first one could be a really wide single kicktail short deck like that killdozer. But maybe thicker around 14-17 plys with a pocket underneath for electronics.
Do you have to let the compressor run the whole time? How much pressure does it reach?
4 Likes
Thick with a recess for batteries sounds kinda rad.
4 Likes
The compressor only runs when needed. I press snowboards at 95 degress celcius for 20 minutes
2 Likes
dat’s sexy as faaaaaaaaaaak!
5 Likes
I am trying to come up with a good reason t give my wife why we need something like that is our garage. Other than it is so fukking sexy, because she might not get it.
1 Like
tell her it’s vaguely sexual but you have to figure it all out first
2 Likes
Is that just a compressed air setup?
1 Like
That remind me when i had to explain what this weird swing thing was when we snooped around my dads stuff back in high school 
.
1 Like
I’ll wager heat in there too.
2 Likes
Does it come from the bag? I dont think you could heat the ply/mdf? mold, could you?
you could use heat pads
1 Like
Oh yeah that’s a good point 
1 Like
Steel beam. Mdf bottom mold. Heat mat. Ally sheet. Lay up. Heat mat. Inflation bag, mdf top mold. Steel beam.
2 Likes