Ok thanks, does anyone know where to get bullet conntors I stupidly cut mine off my motors was going to use 3 way xt connectors but can’t find xt 90 way ones thanks
Sounds like you’re looking for MT60 or MR60 connectors?
I’m in the USA, good sir.
2 Likes
@Anubis
https://nexusboards.co.uk/collections/wiring-connectors/products/amass-mr60-3-phase-connectors
4 Likes
opps delete
Maybe I’m going to look very maimed with this but I don’t want to burn anything. to put the esc to work should i put the canbus?
1 Like
first build? start in this thread: Noob question thread! 2020_Summer
Or start your own thread to get help.
is a update, i change a unity for a spinted but unity dont have can bus wire . i think i need conect the can bus but im not sure
1 Like
no that is for connecting an external CAN device I think the connection is on the PCB as with all dual ESCs
^wait this is the on/off switch being activated over CAN
Sorry got confused about your question.
1 Like
maybe for mi shit of english
1 Like
1 Like
@luis99945 definitely no need to externally connect the can bus if you don’t use an external can device or want to run 4WD.
1 Like
thanks
Does anyone know what bullet connectors are on this vesc?
I believe theyre 4mm
3 Likes
so it would go with these without soldering? It says 4mm gold connector male.
2 Likes
how high volts were you planning on trying? 190KV dies over 14S I think.
Yep 4mm
oh im just runnings 8s haha
1 Like
bro on a 75V VESC? that’s baller. Like driving a lambo at 15mph
6 Likes
well i bought it before the price went up so it was the best thing in my price range at the time. I shouldnt have any problem in running it at 8s right?
Im very new to Esk8ing. What do you mean by it dies over 14s?
2 Likes