I am a professional engineer.
On my first job, the owner of the company sent me to work as a helper for 2 months in the manufacturing floor.
One of the best things that ever happened in my career.
This is so fucking hard to find for internships. I had to turn down four offers from pretty otherwise reasonable companies simply because I was going to have absolutely no interaction with anything I was “working on”
And, in general - I think there’s a reason for it. Most mechanical engineers are perfectly fine crunching numbers and bullshit at a desk all day, every day, for fuckin life. Don’t understand how you can do that without wanting to blow brains out.
Then you have to filter through the few internships who are really just after an educated mech E to be an underpaid floor monkey for a little while. I settled a bit for what I just did my co-op with - but being in San Diego for 7 months was mostly worth it.
How long after college did you get your prof license? Having a hard time deciding if I want to go that route
You should try to buy a cheap TIG and learn with YouTube if you are really interested.
I learned by watching my wife’s uncle, I am far from @taz level but i welded part of the structure of my workshop’s roof. My welds can be improved but they hold.
It gets better. I dropped my vx1 from waist height on grass/mud. Now i can’t drive anymore because the thumbwheel doesn’t work. The vesc just receives a constant braking signal. Metrs ppm calibration doesn’t open.
I am in Greece so the procedure is different to the US.
To become a professional engineer it takes 5 years minimum in the university which leads to an engineering diploma equivalent to a master’s degree. Then you can immediately apply for you exams to get your license.
After that there is national legislation that requires extra years of experience in specific fields to sign for certain kind of stuff.
There is another engineering degree which you can get from technical institutions after four years of study but they don’t have all of the rights we do.
Epoxy them all (up to some of the wire insulation) to the case (rough the case up a bit) so this doesn’t happen again
Also, carry screwdrivers and tape with you haha. Could’ve opened up, stripped wire with your teeth, taped to the solder joint, and carefully and slowly skated home.
@Skunk came out of literal fuckin nowhere and saved me on the side of the road after my remote trolled me & I was caught without a screw driver
Well it was my fault. I always have the wrist strap on because i sometimes just let the remote go when i use my phone for example. I was taking a small brake and i already took the strap off but still held the remote until i…dropped it.
Screwdriver is next. I basically have everything on me.
Flashlight, extra battery, pump, extra bearing, stuff to fix a flat, hex keys, a tea bag, 1 extra shockblock, extra belts, a 3d printed nut tool and 1 extra loop key
With my next build Im really aiming for only having to carry a T tool, small screwdriver and an hex key on me… I hate playing guessing games with hardware and tool sizes because im too scatterbrained to remember exactly what size tool is applicable for a certain section of my board