These are prototype…
3 Likes
They look awesome.
I had a much less impressive crash a while ago and bought every single pad to wear including sanitary ones.
2 Likes
Yep, who doesn’t like some deep dish wheels right?
3 Likes
Wondering what this does for bearing spacing / axle length / rim width. Also noticed that only the driven wheels have bolt holes.
Are you trying to start a dual remote argument?
1 Like
wow 
they are beauties ! !
2 Likes
Yes they are indeed beauties!
1 Like
From what I have been told. I don’t need truck extensions on MBS trucks anymore. It probably means two bearings on the wheel are close together. But it has so much offset, you can still use 9inch tires.
2 Likes
@dougpage Did you just cut axle spacers using a waterjet? LoLz, nice. 
If you have access to waterjet, you should cut some motor mount plates out of 1cm thick aluminum and weld them to the truck 
3 Likes
I feel your pain
2 Likes
Is it that hard to reach?
2 Likes
Have an older VW?
Annoyingly so!
Just for a lightbulb! Pre 2012, Golfs required you to do this just to get to the lightbulb. Oddly enough this IS a 2012, but earlier production model, so it still requires all this work.
2 Likes
My fav part of any build is before adding the enclosure/guts… looks great.
3 Likes
Not a pic reply but dont care it’s as good a place as any.
What wheels in your suit have motors and how do you control them?
Tu est malade de rouler à de telles vitesse tête première 
3 Likes