It’s from a mate’s board. It was acting up and i discovered a phase wire was not connected when i pulled on it. Cut the insulation off all of them to check and they were all stuffed! He said he had some bad stacks few weeks back and probably pulled on phase wires hard somehow!?? I’m surprised it worked at all!
I tried a repair job for him but the bloody phase wire tabs came off the PCB. Maybe i used too much heat, maybe they were already damaged
Sending it to someone else to fix as it’s out of my depth now.
sadly I could not print good enough hubs. I think they would come out a hell of a lot better if you used 10x28 bearings. Metal cores off a trampa with a printed adapter from there would also be good.
That entire set-up is a custom deck + enclosure system that @Skyart and I designed for SKP power systems. It was a pretty big project. I’m extremely pleased with the results.
Now, if you just want a logo put on a deck. I can do that too… unfortunately, not retroactively