yes its Acedeck…
Considering MBS is retiring the old truck design which probably means the old shockblocks are going along with the retirement… guessing the mold was “borrowed” by other makers
I drilled out the adapter holes with a 4mm drill, no sanding screws required
Yes i did that too after . I was kinda scared that it might become too wide but it worked out great.
Unless you mix metric with freedom units. Dumb me didn’t realize I had both types of bits
I’ve been thinking heavily about this, did you make the mount for the rear wheel or is that something one can buy?
Is your dog a little monster? Percy is a madman.
Why are we talking about dogs and not the hubs
They’re looking good. I should have them on my website sometime next week.
Are they standard diameter and width for 6-8" tires, or something special?
Don’t talk about his dog like that
Yeah Frodo can be a little bitch.
Mine is definitely more than 6-8” wide, that fatass
They’re wides for 6-8" tires. Super-strong Nylon-6 with fiberglass. They’ll be about $120 for a set.
A set as in two or four?
Four!
Daaamn what a deal, I’ve been waiting and I’m ready
more than 15 - 20cm wide