🖼 Reply to “Pictures and nothing else” thread_2020_summer

Media
#67

Don’t do that pls.
Send it my way I’ll rescue it for ya lol

1 Like
#68

Do you have any wooden dowels roughly the diameter of the inner bearing race?

#69

I have a chronic version of osteomyelitis ( infection of the bone) in my femur. And it decided to grow a shit ton and break it’s way out of my femur and get into my thigh.

Just recovering slowly right now!

6 Likes
#70

The actual definition of a cautionary tale :slight_smile:

6 Likes
#71

Absolutely toasted. Honestly idek what he did to manage to destroy it this bad lol @mmaner

1 Like
#72

@rafaelinmissouri

When did you get the 3d Servisas pulleys and how long did you ride them on the Boas?

1 Like
#73

Hope he wore a mask

3 Likes
#74

I hope he gets laid, that’s some rage there :slight_smile:

5 Likes
#75

I got the pulleys yesterday…(waited 6 weeks)
And rode on the Boas once…
I knew the TB 100s were getting here today.

3 Likes
#76

Oh that’s really unfortunate

4 Likes
#77

Those were really really tight holes. Should the pins be that soft tho?

1 Like
#78

Yeah. The lesson learned is not to use 3d servisas pulleys with Boas…
The holes on the core were too tight.
I should have known it was going to be an issue with how much I had to beat the pulleys to go in.

1 Like
#79

It almost looks like it fused with the core. Crazy.

#80

Where did you manage to buy that many magnets? What strength are they?

#81

FWIW, I have a set of the 74a 100mm TB wheels and 3D Servisas pulleys. I found them to be EXTREMELY tight compared to the cores on the 110s. Minimal pressure required to install them, but very tight tolerances when I tried to remove them. I was concerned they were stuck but I was able to very slowly apply pressure from opposite sides with a plastic tool and after about 10 minutes of micro rocking I got them free. Sorry for your loss.

2 Likes
#82

How do you like your 100s? They are what is coming next.

#83

I have not found a board that I really like them on yet. I think they would work well for a shorter narrower build. They seem too narrow for 220mm trucks. Personally I prefer the new Boas for the 100mm wheel size. The wider contact patch makes up for the firmer compound. I am curious to see what you think about the TB 100s. I thought they felt a little too bouncy on rough pavement.

1 Like
#84

Mine are to replace the Boas I thought were too hard… Going on 220s…

#85

How do you like those trucks ?? @yelnats8j

#86

I think that’s @Juddymuddy’s board :grin: