The esk8 vendor community should consider joining forces to hire a full time liaison over there. The safest assumption is unless someone that works for you sees your parts on a machine someone who is doing that will have their parts on that machine. We have a slightly bigger budget but we have an army of liaison engineers across the country doing just that. We share them across divisions. Just a thought.
2 Likes
While we are on this subject, anyone else dislike the position of the lanyard/loop thingy?
all good, thanks 
if a Mini Puck is ever in the works, consider me your first tester 
1 Like
Kevin Graehl was toying with something to minimize. Hit him up.
4 Likes
Oh yeah…
Looks like there’s quite a bit of wiggle room to make a smaller puck shell, too.
4 Likes
Sounds like a lot of people here are used to gripping smaller diameters. Possibly overcompensating with 13s and 6380s also?
10 Likes
Now give me the stl… 
2 Likes
Do these dimension look ok to you?
I’m not sure what width I can make the bumps, just guessing.
also should I just round those edges or keep it ballsy?
4 Likes
what’s the height? i cant read it
maybe a slope from the nub to the base
1 Like
3mm
5mm total to the top
charz
2 Likes
5 is good, was thinking 3 might not be enough
1 Like
Ah jeez, here we go again. Do you have the later one with the recess for the lanyard to fall into?
6 Likes
what orientation would you suggest for printing?
also could you make a version with wider overall nub? 
I just drew up a couple This is one version that I am printing now, I’ll see if it feels right and post back or print it and see, file attached.
hoyt puck thumbwheel.STL (327.3 KB)
10 Likes
Chill Jean-Jacques, at least I am not asking for a kid’s version of the puck.
I think I do. It’s the Late night puck.
4 Likes
