ok, here is the crazy idea, remove both truck and drivetrain, slide a wide and long enough heatstrink over the deck and enclosure, heat it up, repeat again if u want, that should hold the enclosure but im not responsible for anything happens after that
holy shit ur a genius
not actually doing this but like big smart
not my idea, i’ve seen someone did that in a video. i just happened to remember random stuff like these
this person needs a trophy
Along a similar vein, velcro or nylon cinch straps? I’ve seen it used to hold top mounts in place, don’t see why it wouldn’t work for a light bottom mount, plus less grip tape covered.
anything is better than layers of packing tape
get a few strings and tie it over the deck?
https://www.ebay.com/itm/Moose-Skateboard-Cruiser-Deck-Neon-Green-8-x-26-5-BRAND-NEW-IN-SHRINK/372866929525?hash=item56d099d375:g:4CIAAOSwKI5eWS53 the solution to my problems
if it works, then it works
This will be the deck for my dual 70mm hub board. its gonna be
10s1p 30q
shit deck
aliexpress hubs on a 7" truck
8 inch front truck (because screw consistency)
3d printed enclosure
fire hazard
aliexpress esc
OH NO
This will probs get you like 7 miles haha
more like 4 considering I live in a city
I’m fine with that
so far ok, maybe not the fire part, but ok
vesc based?
final cost is like $300
oh boy
It’s a bunch of spare parts, some don’t even work well as they were run over by a car. Long story short credit card insurance covered it, which let me buy good parts
oh boy²