Life saver. It was really starting to wind me up haha
2 Likes
Do you pros recommend against VESC4.12 hardware like the MTVESC50A for a first build (single 6374)?
VESC 4.12 is completely fine as long as you use it at 10S, no more than 25A battery max, and in BLDC mode.
If you try 12S or a higher battery current or FOC mode, you might have problems.
I also recommend unsensored for other reasons, but this results in needing to kick-push once as it won’t start from a stop (but even at 0.1km/h it’s fine) in BLDC mode.
1 Like
Buy Wera Hex Plus wrenches to prevent this problem in the future.
Also this
And to get that out you could try this
https://www.amazon.com/gp/product/B07VFM3Q5Y/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
1 Like
I’ll try drilling a hole in the screw with a… Drill
Will buy wera!!!
No, those drills cut while turning counterclockwise. They aren’t regular drills, you have to turn them backwards
1 Like
Option B is to cut a slit in the bolt and remove it with a flatheat.
4 Likes
Yeah thanks! Tried with a powered drill, but no success…
No easy way to get them out?
Idc if they survive… Just want my motor 
dremel
3 Likes
And if you don’t have a Dremel?
1 Like
buy
7 Likes
Do they have blades small enough and strong enough to cut through bolts?
1 Like
research
6 Likes
Love the one word answers
2 Likes
Dremel
3 Likes
yeah mine stripped too those are shite
1 Like
i drilled it out and then used pliers to take out the threaded part
2 Likes