Ok so after using this remote for awhile now. I think I’m going to hold off on putting it on more than one board.
I didn’t have any major issues. However, I had enough that I’m slightly sketched out by it. It appears that the signal is MUCH improved over the V1 receiver but it still doesn’t handle massive amounts of interference well. Seems to mainly be an issue if you are rolling through an area of high interference slowly, probably because of the prolonged exposure to high interference. When I did have signal issues this is what happened:
Went unresponsive if I was not moving. Then one time it did actually kinda jerk around on me while I was moving. This was on my commuter 12s3p with a questionable Unity installed at low speed. So I’m going to test more on a board with dual focobox’s but I am for sure sketched out about this remote again.