Also had to put in a skid plate because my enclosure scrapes on hard turns still
Size isn’t 100% perfect yet but it hits first so that’s fine
2 Likes
Can I see the whole set up?
Yeah, I’ll snap some pics when I get home today. The issue I think is because I have to use such a tall riser to accommodate the Lonestar super sport enclosure. It creates so much leverage on the pivot point that getting it tuned to feel nice is a little awkward
1 Like
(Temporary) Front riser with single -5 degree
Rear with two -5 degree wedges.
Gets it feeling good as far as geometry but the rear centers too hard on the wine d for my taste and i have to turn and carve from the rear. Gonna swap back to b/c and try these angles again. See how it feels. My gut tells me c/c is my sweet spot but i want to go down in duro or get a wfb for less bounce
2 Likes
1 Like
That is in fact a lot of risers…
I am having the time of my life riding these Singularitys on my LaCroix deck!!!
But I have a top mount box…
2 Likes
Tried c/d on the 25/15 and switched back to b/c with the new lower angles and it’s the sweet spot! Was just gonna do a quick loop but the suns out and it clicked just right. Spent a couple hours getting the feel. I think id like to try a b/b and a c/c setup but this is good.
Need to come up with a solution and rework the risers. Optimization after proof of concept 
gonna think on it a minute
2 Likes
I have not tried the same shapes on rear and front…
With tires I settled on B/C
With the MAD 101s I went A/C
Either way it’s so much fun for me.
The super lean is awesome.
1 Like
They feel very predictable too. I run very loose trucks and these were eating up potholes and trash roads in the 25-35mph while still pulling u turns on two lane roads and carving low speed and middle speeds like a champ
3 Likes
You still have the spacer in stock?
Looks like i dont currently unfortunately. If theres enough interest i can run another batch.
Can anyone confirm if the Matrix III truck works with Trampa Conical motor clamps? The Trampa hanger measures 20x20mm and the Matrix III hanger is 22.4x22.4mm. Curious if anyone has looked into swapping to them and if they ran into any issues. Cheers.