The hundreds of pounds was when the grub screws got stripped and I had to use a bearing puller to remove them.
You should thread in a longer bolt and use the puller on the bolt. That’s why you damaged the rings.
The puller never touched the torqueboard pulleys. I “damaged” them with my fucking thumb.
The puller was used to remove the original pulleys with stripped set screws.
I personally agree with you, anything that TB doesn’t make in-state (everything sans tb110) is just cheap rebranded aliexpress shit. He lost my support after the all terrain wheels problems and lack of giving a shit in general.
The tb110s are made by labeda. Same people that mix up abec11s urethane.
I have a friend running tons of torqueboard stuff. A lot of it’s cool.
These pulleys blow. @Boardnamics had their chance, I think I’m going Janux.
Good luck, not sure what he has left.
He’s closing shop.
Are there any stainless steel pulleys (no dark steele) or at least raw looking pulleys but not made of aluminum out there ??
The pulleys that we’re originally on could be sanded down super easy. I asked @Psychotiller where he sourced them or if I could buy a set and got no response. The original pulleys were strong as fugg.
1 Like
Epoxy them back on. Sand it clean first.
They were in stock when I looked recently. I’m losing skate weather…
No one knows of a set of alums or anything that’s on amazon prime?
I don’t understand this.
I definitely would have just epoxied from the get. I have never had trouble sourcing something like this.
Fast, good, cheap. Pick any two.
If you want good pulleys fast, order TB ones and some epoxy from amazon. Not 5 minute or quick epoxy. West System 650 or JB Weld 8265S Original Steel.
Push the rings off, sand it clean, and epoxy them back on. Easy peasy.
You don’t even really need the retaining rings if it’s aligned well.
This is DIY. Do it yourself. 
1 Like
This. I ran a board for almost a year with no outer retaining ring. Never had a problem.
Maybe @kevingraehl has some extra pulleys to sell. Guy has everything else in Stock it seems.
1 Like
Yeah, apparently he has some extra Fluxmotion enclosures as well 
1 Like
7 left. Maybe. Kinda. I hoard them
My shipment of 50 pullies is in route. Dhl.
1 Like
What kind of pulleys?
8 and 10mm keyway. Many 16-20t
1 Like
i have 16T 15mm ones if you want. The flanges aren’t just pressed on, they’re also stamped in such a way as to keep them on.
2 Likes
Fast and good. There, picked em. Where do I go?
This is my setup. That’s a 20mm 12t motor pulley. I’d like retaining rings to pull the belt towards the inside of the versapulley so there’s some clearance between the belt and wheel. How am I supposed to do that without retaining rings? Why would I? There’s a reason pulleys come with them.
I’m not spending more money on torque boards pulleys- I’ve got a set of 12mm Tb pulleys, I’ll just spend 7 bucks on belts and run those.
This is god damn ridiculous.
Edit - the picture looks like the belt is slightly bent? This isn’t actually happening.
Did you ever try mine? Tracking says they were delivered a while ago
3 Likes