Thank you
3 Likes
I think I’m blind, where was it mentioned?
1 Like
I’ll post a 3D file of the rim/wheel interface (for both 5 and 7" next week) so y’all can design your 3D prints off an accurate interface. If you dont hear back from me early next week, ping me here.
9 Likes
Now that is mega epic!!
You are so solidly in The ESK8 Vender Hall of Fame.
7 Likes
17 Likes
It would be cool after there are some options to have a little competition to see what 3d printed design people like the most.
2 Likes
3 Likes
Holy shit, what are those on the right?
3 Likes
Tb130
1 Like
Why no logo? Just curious.
1 Like
These are just prototypes because they were never actually sold
1 Like
Partial delammed tb130s 
I’m gonna mess with them over winter and try to figure out what adhesive I can sneak in there.
That were fun for the 50ish miles I rode them
7.5mm taller than a can o beer
6 Likes
hmm ok seems nobody bothered to upload a model of complete tire and hub…
if you drop a drawing even with no dimensions it would help get the profile right.
Why would someone upload an entire model of their proprietary work
That’s like asking someone to copy it
3 Likes
I asked for a model from anyone, if @JJHoyt wanted to give the tire profile that would be nice to skip guessing that curve.
I see, what exactly do you want that for lol
Approximating curves isn’t too hard, also, when tires are pumped up they aren’t always gonna be exactly the same curve
1 Like
Good for guessing clearance with other parts and making mud guards
1 Like