it looks like that 10s gave up quite a fight, opening it up!!!
I was going to open up one of my Daly BMS’s to reroute the wiring… but I guess I won’t be doing that now…
you can get it to fit if you try hard enough
I got it to work. Cut a small piece off the end with a knife
Still happy to send you a 13 pin / 12 s connector… Or anyone… Should just be 2 stamps/ envelope…
for the Daly bms, where are the P+ and B+ leads? I only see P-, B-, and balance leads…
I’m really into the idea of having a US based stock of BMS’s.
Could I buy 2x12s and a 10s Daly boi?
I’m going to be buying 16s only from now on. You just bridge the last wires to compete nthe circuit. Same size as the 12s same chip. @Winfly helped me on this. Ordering 30 of these and 20 12s to those who are skeptical of soldering the last 4 pins/ wires.
A bunch of pinions too. And bolts/. Etc.
Give me a 2 weeks.
It’s charge only. No need for the other. One for the charger. The other goes to battery. Thats it. Simple and quick
I’m down for 2x 16S
Just sent $505 bucks. Took two weeks last time. Once I get tracking. I can spare some of my secret stash
Dayum… das sum quikidy quik ship.
I’ll be in for 2x 16s
I opened the 12S bms and found the data sheet the IC they used. they always populate all 16S and the IC is capable of 5-16S without any Selection pins. The way to adjust is like this diagram
Shorting the extra pins to the highest voltage pin.
Wing! You the man!
16s BMS’s for me and my men… 10s for the horses…
I wish I could like this more than once!
I have a bunch of these daly bms in 12 s and need assorted voltages, you just saved me from ordering a bunch of shit i dont need
Can you very you can turn a 12 into a 10 for me. Today is house chores. No esk8
Are they easy to open?
Yee. Just clip th corners. Then rubber peels off
I’ll make a video tonight if you need or wait till you get yours. Takes 45 seconds. Thought it would be harder. It’s basically hot glue status with less stick