i backlash based on feel
i jiggle the wheel gear to make sure there’s some movement and call it good
like go to complete 0 backlash, then literally just bump the motor back, check, and if it’s good toghten slowly and then double check backlash
very successful with that method
They use their own modulus, not standard.
Well, so do I now. Thank you scale tool.
Just casually flashes a Colab
You gonna need to run this on a bracket board so you don’t get motor bite
Yeah, that and trucks that aren’t 3d printed.
This is looking very interesting!
I don’t know who needs to see this, but it’s awesome. It’s like a coloring book of engineering and material science for non-engineers.
Had some material trials. Tuned PP gf, failed PPS, dried HTPA Cf and printed.
Fell into rotary shaft seal rabbit hole, Jesus it was deep.
Played with a dumb way to die that’s been on my mind. For those that fuck with their trucks:
The pp
This scares and interest me. Getting that rear truck with the drives attached and the esc box still wired to it was a pain on the DW MBS.
This is most definitely not a serious set up with truck mounted like that.
Got brim 
Reminded me of this. Qwik Pack B – Qwik Truks
Kind of interesting, I may order a set for some shenanigans that theyre not made for.
