Haha, happy to share. It’s a rectangular cross-section double cantilever snap-fit design. So here’s the mechanism -
View of the slider rails:
Full close
Full open (captured)
Before install
Small detent provides a positive indication of full open (captured)
M3 hex nut pockets and cable routing hole. Once the XT90 Male is installed, the nuts should be captured.
Sliding piece has the two finger concavities for a good grip.
The fit is quite tight on all parts, so we’ll see how the assembly goes. I’ve already made a few loopkeys with the dimensions for the XT90 male and female pockets, so I know those are spot on.