esk8.news esk8 calc donate now

WTS: TPE trampa concave pads

I initially 3D-printed these TPE concave pads for my MTB but decided to head into another direction. I would like € 35 for them. Shipping with DHL tracked: in EU €10 euros Shipping outside of EU estimate of maximum € 22.

50% infill, 5 perimiters (2mm wall thickness) and 0.1500 layer height.
They feel really great on a flat deck like a trampa board! And can even replace bindings. They can fit multiple decks because the pads are flexible and the TPE can be cut rather easily with a sharp knive or scissors. You can attach them with strong double sided flexible tape or glue them on.

Here are some examples from forum members:

Build with modified Jonny1983 concave pads by Taz: Trampa 12s7p, VESC6, 6374 sk8, e-toxx mini gear drive

Jonny1983 concave pads on sedmii’s build:

Design credit to jonny1983 on thingiverse: https://www.thingiverse.com/thing:3227325

2 Likes

Hey no offence but I think it’s a little expensive for some 3d printed stuff, especially when the design is not yours and available to everyone

3 Likes

No offence taken. However TPE is not easy to print, the material I use is not cheap either. Plus it took me a while to dial in and the parts took a lot of hours to print. But im open to offers aswell.

3 Likes

Bump €25 excl. shipping

How long x wide are these?

1 Like

I will check in a bit :ok_hand:

Width 58 mm length 200 mm

Bump €20 excl. shipping

What can you do me for cheap untracked to Ireland?

1 Like

28 incl. shipping. Cant go lower shipping to Ireland is apparently quite expensive lol

Sounds good, sending a DM

1 Like

Sold, @BillGordon thread can be closed

1 Like