Freeze the bearings before pressing in
Try using your hanger as a press. You need some washers (skateboard flat washers) on either side and some spacers to tighten the axle nut
Yah that didn’t work either. I’ll try it with frozen bearings and maybe heating the seat too before I go find a press.
Probably need to sand the paint off first
freeze bearings man, I had to do that for my 3Dservisas fat boy pulleys where I had the same issue. Me also no have arbor press =(
Anyone here tired of theirs and willing to sell them?
Looking to buy the 15mm moon pulley.
A tool that everyone should own, good job.
Looks like I need to go to harbor freight
8mm ID 10mm OD 4.5mm length
Still on the list?
This aged well.
Ehhh it could be done but not sure if there’s enough demand
Yup. Let us know if you do. (just picked up a used set) Axle length mission also for bearing pulleys, but replaceable axles could be an option with a collar like akhlut did for SR rkp? Dunno. No drama. Not common so numbers prob not gonna work
I counted like ten times and mine have 33 teeth.
Is there any semblance to the Evolve situation where their “32T” pulleys have 33 teeth?
I’ve lost track. Everytime I’ve made them I’ve changed the tooth count slightly
Send me a pic and I’ll hunt down my drawings
I just want to say I’ve been riding my Magnum dongs and loving 'em.
Nice pulleys yo
Oh nice, I have the best one (for me) by accident then. Sweet!
I’ll be adding flanges myself
Might not make these again so here’s the design file as some people are requesting it
6061 33T HTD 5M 15MM - FMACH v1.18.step (702.3 KB)