[Tuning Stage] III:THE EMPRESS | Apex Bro / Airs / Chain Drive | 6384 140 kv 5:1 | 12s2p P42A | DV6 | | 8" Rockstar II

[sleepless]

How did the fit turnout?

I should’ve mentioned, this is the recommended slicer settings, if you hadn’t seen:

@sleepless

Recommended Print Settings:

• 0.20 layer height is fine (lower will only improve)
• All the walls (20 perimeters, 10 top, 10 bottom should max it out - this is stronger than using 100% infill)
• ≥4 perimeter walls, 4 top/bottom - # of walls is important to get max strength in the slider arms
• ~20% infill (i prefer Gyroid pattern for strength and speed)
• “Mount” set vertically (opening down), “Slider” set horizontally - this is important, see below
• Brim on “Mount” to ensure 1st layer adhesion, as necessary
• No support required Support on the “mount” may be required to get a good fit for the female XT90, depending on how good your printer is at bridges.
• Should come in around 3 hrs for a set
  (PrusaSlicer settings:)
• Avoid crossing perimeters ON (to avoid stringing inside the cavity)
• Seam - Nearest or Aligned (for nicer surface finish / avoid zits)
• External Perimeters First - this allows for better dimensional accuracy on the “Mount”, which enables better fit between parts
• Thick Bridges - this may help the bridging on the “Slider” if you don’t use support
• Enable Ironing (topmost surface only) - if you want a very nice, smooth top layer