FrieNDA for my patent pending wheel lights
this looks amazing!
Do you think theres room down there for a 12s4p 21700 battery pack?
I don’t know for certain but the next time I open I can measure the space. Kinda thinking it has enough room since there is a gap on both sides of the current battery
Pretty good.
Is a solid double redundancy system and on the metal tabs was introduce a stress damper system perfect so far.
BTW
I got a cool hardware for you
Because I’m pretty?
Kaly, Can I send you the payment through paypal? If so could you pm me?
Where can i get this PCB?! Beautiful.
very jelly.
Awesome build with awesome parts! Love the enclosure
Thank you! The enclosure is actually working out really well. I added a second layer of packing tape since I hit water along my routes and used some foam to stop crap from flying into the opening on the front side.
I’ve been taking this build out lately and it’s been a lot of fun. The free roll is ridiculous compared to what I’m used to with pneumatics and a higher gear ratio. Haven’t been able to work up the nerve to hit full speed since a hospital is the last place I wanna visit right now, even if they have good drugs. After the outbreak that’ll likely change
@torqueboards this would be a bitchin’ complete that could run with the big dogs for sure. Could even sell it like Prusa sells their i3 printer, where you can buy it as a kit or fully assembled for additional cost.
Wow does torqueboards ships a free enclosure with every deck purchase? Or is that all custom work with a torqueboards sticker? Its great either way!
It’s been a while since I’ve updated this thread!
After a long series of 15-20 mile runs on a carver I took this board out again tonight and was reminded A) how scary it can be and B) how much fun it is on a track.
The enclosure was upgraded swapped for a prototype Dexter sent out for testing.
I put in one of the Toughwire Antispark units and it’s been working wonderfully. I like the push to start feature but wish it had come with a button sometimes. Not enough to actually install one myself if that tells you anything.
I’ve only really come across one QC issue while testing a TB6 and I see it’s already been addressed in the current units that are making it out into the wild here and there.
IMG_0516
I had to apply more loctite and tighten one axle that started backing out. I brought it up and see it’s happened a time or two to others. Still, it’s a good idea to check your stuff every now and again.
No bending of the long motor mounts with cross braces installed but I’m keeping an eye on them since it has large motors.
Hoping to get my hands on some of those giant wheels @torqueboards has in the works The sidewalks here are just too brutal for this rig and the streets are slightly sketch but it still gets out
That first enclosure was the ducks nuts you’ve inspired me to try a new method for making my next enclosure buck, thanks!
Wicked! Any time
really nice clean build
where did you get the vescs from?
may you share the vesc settings on those motors? would be really nice
Thank you! I’d have to pull them up again. Pretty sure it’s mostly the default settings and maybe dialed down the amp limits a bit.