Amazing. You got far enough into the Trampa website to read an actual product description?
On another note, yall notice legit that Trampa descriptions look like the essay you wrote in high school 2 hours before it’s due after you got back from a party?
I would put more holes through the centre bits for better airflow… unless you have a beast vac and it doesn’t matter…
I swear I have seen a photo of a stack of uncut trampa decks just like you’re describing.
Installed my 58KV Elofty drives with haggy wheels on my Evo to try them… mainly since the sensors on my 6355’s finally shit the bed today. I was trying to save these drives for another build I have going. Now both drivetrains are down 
These drives with haggys are a blast. Dead silent operation (untill the can unscrewed, locked than proceeded to scream and I went running off). I weight about 120-130lbs and these things had decent torque and had no problem with the one hill I hit. Got a solid 2 miles out of them before the can unscrewed.
Yeah I know but I’m not doing any of that lol. I think Nathan is gonna get me a replacement set. I just wish I could of had these exchanged/replaced before the issue happened as it now sets my build back. Also… Chinese new year, so I hope I’m able to get a replacement soon.
W0W… Right hand-side motor… That makes 10 motors that I personally know about…
Mike gets me😂
Lol! Hi I’m Serineh 
don’t think I met you while at Lancaster! hope you have a great night 
@anon86070286, Let me guess, Lancaster was easy too 
True, I did abandon you with s5300 for a minute 
Congrats on the race, Mike, you absolute savage. But @anon86070286 is kicking your ass in here.
I love how the brand is Unimig and the welder is MMA and Tig
My mig welder is a cigweld 
A MiG-21…
My grandpa told me some stories about that thing, because he was a mechanic lol
Is it a plasma cutter too?
The Hypertherm is a plasma cutter. Nothing else.
The Kemppi is MMA/TIG AC/DC welder
