as a charge port. looking to grab a 10a charger and the old 2.1mm barrel wont handle it.
at lease that was a DD with full thanes, your board would’ve exploded if it was a Raptor 2.shit
Where is this cluster of urethane with giant sharp shit in them coming from? Was there an Eskate meet up near a scrap yard I missed?
Lol just wondering for future reference
I’m going skating near pillow factories and angel pube dumps after yesterday’s spill.
Edit: yes I’m drunk and I stayed home.
These are prototype…
They look awesome.
I had a much less impressive crash a while ago and bought every single pad to wear including sanitary ones.
Yep, who doesn’t like some deep dish wheels right?
Wondering what this does for bearing spacing / axle length / rim width. Also noticed that only the driven wheels have bolt holes.
Are you trying to start a dual remote argument?
wow they are beauties ! !
Yes they are indeed beauties!
From what I have been told. I don’t need truck extensions on MBS trucks anymore. It probably means two bearings on the wheel are close together. But it has so much offset, you can still use 9inch tires.
@dougpage Did you just cut axle spacers using a waterjet? LoLz, nice.
If you have access to waterjet, you should cut some motor mount plates out of 1cm thick aluminum and weld them to the truck
I feel your pain
Is it that hard to reach?