this?
4 Likes
Yes. But my board is broken so Iām dead inside
4 Likes
I fucking feel this in my soul, I still need to fix my main board. Crashing sucks 
2 Likes
So whatās the story?
2 Likes
3 Likes
I love this build so much. I am very tempted to give this style a crack myself.
3 Likes
Oooh you going to take custom grip requests 
Haha havenāt thought about cutting grip tape in there but it might be interesting to try. Not sure if Iād just light it on fire by mistake 
I used it to make my little Hercaleez name plaques and one for my doggo
1 Like
That is super kind of you to mention me - I really had fun on that project and writing it up.
Not this winter but probably next winter I am going to try to do a full suspension mountain board from scratch, so it will likely be just as long and mistake intensive as the Sand Runner was 
1 Like
Iām looking forward to it, just donāt let it burn this time^^
Iāve thought about cutting grip, hopefully it would just be adjusting the settings. But Iām too lazy to make it out to the workshop and have to get training.
Unfortunately this laser can only fit 32āx18ā material so it canāt cut a full sheet of grip anyways. Half sheets of the thicker foam tape would probably fit in though.
2 Likes
Fortunately though, itās a laser, so it can cut two pieces that fit together very nicely 
2 Likes
Wow, thats a great offer!
Dude howāre you liking that wheel combo? I just bought the tires and probably will also throw them on Hubbas.
1 Like
Theyāve been great, zero complaints
1 Like
@frame any chance you tried mounting these tires on BN GT3 or Hubba Hubs?
I assume the inner width is the same as the meepo cyclone at 49mm.
2 Likes
Itās wider than meepo cyclone racing, and Iām pretty sure they donāt stretch, them walls are stuff af
2 Likes
I guess Iāll have to wait for @ShutterShock to take a tire off and measure the inner diameter. I really like those tires, but I want to run them on hubs that take bigger bearings. The 10x22 are fine but they donāt make me feel warm and fuzzy at high speed
2 Likes