I am fine luckily.
The remote was having connection issues I believe and it just shot out from under me from a dead stop and tried to ramp off a curb…
2 Likes
what are those…the hubs
1 Like
The dickyho airless wheel hubs… they seem to be metal…
1 Like
I’m looking forward to seeing you wire this up. No matter How Much I draw the 3s2p balance wires there’s never a clean way. Long routing them at least gives a clear distinction between the left and right side:
1 Like
gt2b.
See Justin, this is what I’m talking about. It’s sort of fake but it’s nice right?
3 Likes
I’m digging all these nature playgrounds recently. Great to get your kids dirty in a new way.
I did pass a huge dude in a furry costume living his best life immediately after.
5 Likes
It’s only funny bc my drawer of shame has similar looking tips. Don’t worry, the other 24 who liked this pic have similar secrets or worse
4 Likes
2 Likes
@ThermalChild
🖼 Pictures and Nothing Else!
Can you tell me your set up on the surf rodz length ?? And your motor pulley plate What brand ??thanks🤙
Those are 176mm RKP surf rodz
@akhlut integrated axles (they long)
@Boardnamics 40T pulleys
@moon plates
Shits wide
6 Likes
Nice thanks
2 Likes
Going to look great after you go grind on some painted curbs!
5 Likes
I like the look!
but honestly the painted bushings and kingpin trigger my ADD
6 Likes
it says made in china not tested in china 
@kook they look stock to me so he can always swap em.
5 Likes
I wish I had 645$ burning a hole in my pocket.
3 Likes