I shattered three bones in my hand 15 years ago and had reconstructive surgery and then 6 months of physical therapy. 30k out of pocket after insurance. Fuck big pharma. Fuck the insurance scams. We need to over throw the government and weed out all the politicians that are on the payroll allowing this to happen.
5 Likes
How much? Might want a 4x4 one day on my energized monster
the bed is indeed the Z axis but the ender 5 work with the same system/principel (cartesian) as their other printers.
CoreXY uses 2 motors with belts both connecter to the print head
For example if you were to move the red belt on the left outer side the print head would move diagonally, but he explains it better at 5:50 but the whole video is really educative 
(he even talked about the ender 5 )
4 Likes
This version of the motor mount costs $ 130 + shipping
The voters are allowing this to happen. And especially the eligible voters who aren’t going out and voting, they are especially allowing this to happen.
The whole next paragraph is redacted as to not get into politics on an esk8 forum.
3 Likes
Hold up, what exactly are you doing with that handle up yonder?
3 Likes
Its the Ender 5 Plus, its a cartesian 3d printer 
2 Likes
My wife’s ms infusions cost 60 grand every 6 months. B4 that they were 18 grand monthly.
Criminal shit
2 Likes
The original handle placement below the deck (in the same holes) was in the no-so-perfect spot that it cast a shadow from the headlamp at exactly the wrong place. Like putting tape across the front of your headlights. It’s because the nose is upturned and I’m used to flat noses like the '80s Powell Peralta reissues. The situation is being rectified as you’ll see soon
2 Likes
I used to drag the kid around at the bottom and top of the ski hill with this and a expanding dog leash. Saved soooo much time.
1 Like
Alva Power Station Dogstar Stubbie
2 Likes
Its not a part of a gear its a stripped key (-:
1 Like
Yes bro its a stripped 4mm Key !
4 Likes
How did you manage that?
its part of a 2 stage chaindrive, this key holds a 7mm wide sprocket, so the torque was high enough to sheer 7x4x2mm of steel, maybe someone can calculate whats needet to do so, from our meassurements it was around 8KW …
10 Likes
Meheheheh i want this one to the best comments od the year thread
This smile made my day even if this smile was just for you Mike 
Hopefully you could leave the bad times behind and everything is good now.
All best wishes to you and your beloved ones.
Peace
4 Likes
Did you have to request the 140kvs all special like?