use softer bushings instead hahahaha ok… tkps are not that wobbly(turny) than dkps.
Maybe you could also try to drop the rear like we talked about and switch to rkp on the front. Its against what @b264 says, he suggested Tkp front and Rkp rear so there is that. Could get you deep down, doooood. 
1 Like
well seems like someone is compensating once again xD
btw nice TOES
2 Likes
Damn! looks good! Been wanting me a Hiller for pushing. Quite a while now
2 Likes
Only a matter of time before it gets a battery box 
We get older and older and want to push less and less, it’s like a law of nature
6 Likes
They just love to use those fucking trauma shears… cock suckers.
1 Like
is this the fake coreXY Creality made ? 
It looks like the CR-5 to me but could be wrong
3 Likes
yeah it’s the cr-5 but it looks too much like a coreXY printer
3 Likes
is cr5 not a corexy printer?
1 Like
it actually isn’t a coreXY
2 Likes
does that bed not run as the z axis?
1 Like
I shattered three bones in my hand 15 years ago and had reconstructive surgery and then 6 months of physical therapy. 30k out of pocket after insurance. Fuck big pharma. Fuck the insurance scams. We need to over throw the government and weed out all the politicians that are on the payroll allowing this to happen.
5 Likes
How much? Might want a 4x4 one day on my energized monster
the bed is indeed the Z axis but the ender 5 work with the same system/principel (cartesian) as their other printers.
CoreXY uses 2 motors with belts both connecter to the print head
For example if you were to move the red belt on the left outer side the print head would move diagonally, but he explains it better at 5:50 but the whole video is really educative 
(he even talked about the ender 5 )
4 Likes
This version of the motor mount costs $ 130 + shipping
The voters are allowing this to happen. And especially the eligible voters who aren’t going out and voting, they are especially allowing this to happen.
The whole next paragraph is redacted as to not get into politics on an esk8 forum.
3 Likes
Hold up, what exactly are you doing with that handle up yonder?
3 Likes
Its the Ender 5 Plus, its a cartesian 3d printer 
2 Likes
My wife’s ms infusions cost 60 grand every 6 months. B4 that they were 18 grand monthly.
Criminal shit
2 Likes
The original handle placement below the deck (in the same holes) was in the no-so-perfect spot that it cast a shadow from the headlamp at exactly the wrong place. Like putting tape across the front of your headlights. It’s because the nose is upturned and I’m used to flat noses like the '80s Powell Peralta reissues. The situation is being rectified as you’ll see soon
2 Likes