Yeah Michael, thats cool!
I would drop this board this way, you will love it.
watcha mean? Indys? No. hahahahaha bc I dont have DKPs hahahahaha
Yeah Michael, thats cool!
I would drop this board this way, you will love it.
watcha mean? Indys? No. hahahahaha bc I dont have DKPs hahahahaha
I had to like this photo just so I could unlike it. So much is wrong here
How does it turn when you do that?
I’ve been thinking of doing that with mine but I’m afraid it will not turn anymore
It turns significantly less. For split angle its perfect
Well I have IDEA bracket so I suppose it’s a no go
I’ll try, for science
use softer bushings instead hahahaha ok… tkps are not that wobbly(turny) than dkps.
Maybe you could also try to drop the rear like we talked about and switch to rkp on the front. Its against what @b264 says, he suggested Tkp front and Rkp rear so there is that. Could get you deep down, doooood.
well seems like someone is compensating once again xD
btw nice TOES
Damn! looks good! Been wanting me a Hiller for pushing. Quite a while now
Only a matter of time before it gets a battery box
We get older and older and want to push less and less, it’s like a law of nature
They just love to use those fucking trauma shears… cock suckers.
is this the fake coreXY Creality made ?
It looks like the CR-5 to me but could be wrong
yeah it’s the cr-5 but it looks too much like a coreXY printer
is cr5 not a corexy printer?
it actually isn’t a coreXY
does that bed not run as the z axis?
I shattered three bones in my hand 15 years ago and had reconstructive surgery and then 6 months of physical therapy. 30k out of pocket after insurance. Fuck big pharma. Fuck the insurance scams. We need to over throw the government and weed out all the politicians that are on the payroll allowing this to happen.
How much? Might want a 4x4 one day on my energized monster
the bed is indeed the Z axis but the ender 5 work with the same system/principel (cartesian) as their other printers.
CoreXY uses 2 motors with belts both connecter to the print head
For example if you were to move the red belt on the left outer side the print head would move diagonally, but he explains it better at 5:50 but the whole video is really educative (he even talked about the ender 5 )