$2700 custom cat, thank you very much. That cat is tuned for racing.
9 Likes
It was only $2700??? You really did scam me! I paid around 3500😂
4 Likes
bro is so light
1 Like
The funny thing i thought I was ordering the big size and the smaller version showed up. A bit of a pain to solder though
1 Like
Is this a tailbone light?
Call me “interested”
Do you have a thread on this?
2 Likes
It’s just a piece of transparent acrylic I sanded translucent. The light is just an ordinary light–an iwonder skateboard light in this case. I got the idea from the exway wave and Boosted.
3 Likes
If I could find a clear tailbone that fits Powell-Peralta (8") then I could add SMT LEDs to it.
I feel like ABS or nylon would be a better choice than acrylic though. I’m not sure.
3 Likes
That’s awesome. Great idea!
2 Likes
I made one for my hammerhead hosoi out of pla and it’s been solid. It’s got better impact resistance than a lot of other filaments and they make a clearish filament.
Becomes less clear with more infill and a kick tail would be solid but at least it would distribute light maybe?
3 Likes
Disposable e-cigs should be banned in my opinion. Saving these from the trash, turns out they have decent batteries in them.
5 Likes
You could have fooled me, with those microscopic wires in there.
What gauge are those?
haha, it’s like 30ga? Maybe smaller 0.4mm diameter. Not surprisingly the failure rate of these devices is quite high just from my experience. Another reason why I think they should be banned.
4 Likes
Maybe not banned, but just put a large tax on them
6 Likes
Agreed… you see them littered everywhere along parking lots and malls here in Chicago
here’s one that shorted, they literally have no QC
4 Likes
The benefit of the small wires is they make great fuses lol
7 Likes
Just noticed that riding 6 km home with it flat destroyed the tire also
4 Likes