Ideally you can get an M5 tap and use the threads of the mount as the start but that would be a lot of work and probably not worth it, just making sure there is some loctite between the screw and mount threads is probably sufficient
Inside bracing obviously put on after belt. Outside bracing is 2x 240mm M4 threaded rod covered with 2x blue anodized SS drinking straws.
1 Like
the holes arenāt aligned and I"m
3 Likes
I was talking about the motors 
1 Like
beasts. fucking beasts.
4 Likes
Polish that turd potter.
2 Likes
Sandpaper/griptape
West System 650 epoxy
4 days cure time
Never move
1 Like
what deck is this? Looks like a skateshred bottlenose, which is an awesome deck.
1 Like
I honestly donāt know. Bought it on ebay three years ago as a generic blank deck unbranded. I do love the feel of it though even though itās been the slowest of my builds. This unity has breathed new life into these meepo hubs though 
1 Like
Thanks. Itās EL wire (Electroluminescent wire) itās very flexible and can be cut at any length.
Downsides are itās powered by AC ~130V so you have to have a dc>ac converter.
4 Likes
Iāve been debating EL vs LED strip.
EL is a pain but I really like the consistent brightness along its length. Thanks!
3 Likes
Are you going to do the whole perimeter of the deck, or is that a single tail-light? 
1 Like
Where can we buy those bindings?
Love the size and simplicity Of em.
2 Likes
No, I will do the same on the other side. It will be symmetrycal to the one on the pictures.
2 Likes
Whereāre you from?
I bought them for cheap here but no idea if they ship internationally
https://www.blackkross.com/hooksfoot-stop/15406-hooks-blackkross.html
Yeah Iām in the states.
They seem like a small operation, Iāll email em and see if we can work something out.
Thx for the link!
2 Likes
These rim covers are dope as fuck
5 Likes
thanks C:
2 Likes