My newest printer does. My others don’t 
3 Likes
How many hours?
How do people go at it? Pause, bring in a new piece, and hope there isn’t an air bubble?
Set 20 timers on my phone and feed one roll in as it sucks the last bit in 
Sucks more on bowden setups when the entire tube length isn’t retracting properly but it masks it fine usually.
1 Like
Link to tool please?
1 Like
Please tell me this is a legit BB model!
2 Likes
Definitely, this is going to use 2 80100 motors 
5 Likes
Shut up and take my money!
3 Likes
I don’t remember of top of my head any model number but it’s a big stationary machine that is 5000+
Damn that’s pricey, but it makes good looking crimps that’s for sure.
Is it metallic looking? We have a gold silk filament that looks super cool.
Digging this new nebula filament though
5 Likes
What mounts are those? Look sweet!
1 Like
It doesn’t state silk (sadly) but it seems to be doing a nice job and looks a bit “beige”
So many supports 
1 Like
Thanks, this machine is very easy to use, crimp from picture was basically the first time I’ve used it.
This machine is at work and it’s new so they are still doing tests, validations and procedures so it sits unused for now.
I will look up the model number and make tomorrow so you can at least check it out.
1 Like
God damn brother. That’s a sexy ass board right there 
1 Like
What’s an ass board?
