@Boardnamics are those the SZ axles? what the ETA?
Yep, they should be in sometime next week
they still got the same length right?
The 8mm portion was increased some as per request.
YAY
now I can run enertion pulleys without buying new flanged bearings!
not sure why I would go with small abec wheels on trucks that wide but I want the option dammit!!
-oh your pulleys too
What type of mounting plate is that? Looks great!
d00d i love the look on 'thane… well done!!!
1/8” thick aluminum plate I had laser cut. The hex standoffs I got off McMaster-Carr. When I finish it’ll have a 1/4” thick HDPE sheet for bottom cover and 3D printed frame to close off the sides.
Looks awesome. Best DIY way to deckmount I have seen yet. Do you have a build thread?
Do these fit 6x2 aliexpress wheels now?
They’re 38 or 32mm wide, can’t remember for sure…
They will now!
Thanks. Yeah, I have a build thread, but it’s ridiculously outdated. My plans have changed drastically since I started.
Wait what?!?!?! Have you gotten the Xioxang BMS to work with metr?
Wait a second, what enclosure is that?
Lol funny you ask,
It’s a TB40 enclosure
LISTEN, I had a 12s8p straight pack and did not want to buy another battery, and this worked
How does it hold up to the flex though?
Haven’t tested. Honestly kind of worried, just hoping it works