🖼 Reply to “Pictures and nothing else” thread_2020_summer

When can I start sending you money

4 Likes

Yoo these are genius. I’ll take 4, or happily help guinea pig and print/test too!

2 Likes

Thoon+this+guy+seriously+says+some+of+the+weirdest+_2c4d6f_4692970

3 Likes

Lemme see those gold filament prints!

1 Like

@Jujo
I’ll start by homing it good with the red pla. Still got alot of it. I was told that keeping pla out too long can make it brittle. Is this true?
I don’t wanna waste a perfectly good roll


@Boardnamics are those the SZ axles? what the ETA?

1 Like

Yep, they should be in sometime next week

2 Likes

they still got the same length right?

1 Like

The 8mm portion was increased some as per request.

4 Likes

YAY

now I can run enertion pulleys without buying new flanged bearings!

not sure why I would go with small abec wheels on trucks that wide but I want the option dammit!!

-oh your pulleys too

What type of mounting plate is that? Looks great!

d00d i love the look on 'thane… well done!!!

1/8” thick aluminum plate I had laser cut. The hex standoffs I got off McMaster-Carr. When I finish it’ll have a 1/4” thick HDPE sheet for bottom cover and 3D printed frame to close off the sides.

1 Like

Looks awesome. Best DIY way to deckmount I have seen yet. Do you have a build thread?

1 Like

Do these fit 6x2 aliexpress wheels now?
They’re 38 or 32mm wide, can’t remember for sure…

They will now! :slight_smile:

3 Likes

giphy

Thanks. Yeah, I have a build thread, but it’s ridiculously outdated. My plans have changed drastically since I started.

Wait what?!?!?! Have you gotten the Xioxang BMS to work with metr?

3 Likes


Wait a second, what enclosure is that?

1 Like