I left the existing shitty through holes on it for now so that I can mount boosted gear and get it back on the streets asap 
but, with the aggressiveness of the concave, inserts are basically off the table, so I’ll probably use minimal bolts, epoxied straight through the deck, and re-frit over the bolts. When the time comes.
1 Like
Oh, and I think it’s relevant that I will be using rubber AND metal washers on top while it runs boosted shit. I don’t wanna mess up this finish, after all.
1 Like
happenedI tried to run a single motor 2WD with only one mount. 
8 Likes
Can we get a picture of the “before” I’m having a difficult time picturing this lmao
2 Likes
Which one is that?
1 Like
Sorry, no pictures were taken 
imagine a motor with a through-shaft, which is turning both wheels. I’ll be doing something similar in the near future.
Same exact one from as this one but without the flipsky branding.
1 Like
Ah that’s what I thought
1 Like
i heard good things about it so i’m giving it a shot.
I’m using it to make 2S and 3S packs for the drones i built. 
4 Likes
Nice! I have yet to fall into that pit of obsession but I will one day
5 Likes
My son tells me he wants a racing drone and i think i went over board and built 13. My new addiction. I still ride tho.
5 Likes
Looking good! What trike frame is that may I ask?
2 Likes
Why is it not symmetrical!?
So you could ask about it.
9 Likes
I’m very curious, it do be pretty though
it’s that thingy, to attach the doofer, to the whatsamaflip.
3 Likes
Looks like it adds another bearing to the motor shaft?