You’re not joking around! Definitely following this build. Very nice
That came out clean… What kind of fabric is that? Custom graphic?
custom graphic, yes. I think it’s a 3oz S-glass
Nice . Definitely thinking of doing this for my next project. Looks simple enough and got my vacuum setup almost ready… Keep up the good work
You printed on fibreglass?
No I didnt, but these guys can, and so can these guys.
I’m pretty sure there are a couple guys on the forum here already using both but you didn’t hear it from me.
Not sure if I’m doing this wrong, and at the end of the day will have a ball of rolling fire down the street, but here’s the battery pack as it comes along.
Funny enough this is pretty much the boosted board symbol the closer I look at it.
Things are progressing, really just want this to be done at this point!
The deck graphics need wet sanded, sprayed, and sealed, then it’ll be off to the races to see if I can fit all the electronics into the small enclosure area. I might have to drop down to 3P11S ¯_(ツ)_/¯
You are still working on this one?! Looks great!
I’ve been following this thread on the old forum and on here, this is looking so damn good with every update.
this is legit the most original board i have ever seen. amazing job!
Looking fuckin awesome bro!
Thanks all! Im learning now that I should have done the taillight resin poor last, it got pretty worked with all the sanding I’ve been doing so I’m going to have to polish it to gloss it up again. But still very happy with how it turned out.
What a stunner I have a soft spot for the Darkside you have taken it next level.
Rightly so, its a fucking cracker.
I finished sanding through the ranks up to 800 grit, and now clear coat day is tomorrow. I’m leaning towards matte clear coat but tell me what you think.
- Gloss / Polished Finish
- Matte / Satin Finish
0 voters
Duuuude, you gotta go gloss. It’ll be poppin!
The darkside just looks good in all configurations, but thank you I appreciate the feedback!