Thank you for that 
We haven’t noticed any bearing seat wear on the SR125s. Occasionally the bearing fitment can be a little loose in which case I suggest adding some Loctite around the seat and letting it cure overnight to reduce any movement as that will wear seats over time.
You shouldn’t notice any clicking noise and if you do it should be addressed.
3 Likes
The bearings were a pretty loose fit to start with on mine. On 1 or 2 wheels the bearing would fall out when tilting the wheel. I’ll give it a try. Are we talking about regular (friendly) Loctite 243 ?
2 Likes
I find 243 helps if they’re slightly too loose, but if that’s not enough then you can try some retaining compound (green).
1 Like
I’ve put only 70 on mine and there’s zero noticeable wear, however mine are dead silent. Really grippy wheel eats the road vibrations well. Seems perfect. Huge for my taste - but I already like the size (still prefer 90mm) but this wheel is really out there in terms of amazing I don’t seem to loose much range for a rubber wheel either.!
2 Likes
i have 1500km on them exclusively riding on asfalt road i think prefer even bigger.
1 Like
I have slight rattling noise for my setup. I’m pretty sure it’s due to the spacers not being in contact with both bearings. I had a pretty tough time installing my bearings due to a pretty right tolerance (even with an arbor press). I probably didn’t get them seated all the way.
Spacer length is the same as mbs hubs right?
3 Likes
This thread is giving my nostalgia from when I worked at Hoyt and our bearing fitment trials and tribulations @BenjaminF
3 Likes
Everybody wants to eliminate bearing clicking… Until it’s time to bust out the arbor press…
15 Likes
And then the gear puller 3-6 months down the line.
4 Likes
over uhhhhhh
3500km on mine
they’re roughly ag 117mm dia now
7 Likes
I have two extra arbor presses
(Located in Los Angeles California)
That I’m willing to let go for cheap for fellow bearing pressers
Just regular 1 ton from harbor freight.
If anyone is interested
2 Likes
Great timing i need to replace my tb110’s and dont want to send any more money to trumperica.
4 Likes
Fuck i’d be more worried about sending money to Dexter…
2 Likes
Either way fuck Texas lmao
3 Likes
I did make a purchase from Torqueboards recently and it arrived without issues, though it did take a little over a week for the tracking number to start moving.
2 Likes
New SR125’s with updated core design in stock!
55A medium compound (yellow) now available, and updated core now supports down to 40mm length axles. Soft 45A compound currently in testing.
11 Likes
Have the bearing seats been adjusted or are they the same fitment?
1 Like
They’re not as tight. No arbour press required.
Seat design is also new with double depth on both sides, and we provide an outer ring spacer and two different axle spacers so you can run 22.2mm spacing or 15.2mm for shorter axles (now minimum 40mm length needed).
7 Likes
