Here’s my second build.
Arbor dropcruiser, with dichroic frit.
Bkb 6374 motors
Torqueboard mounts
Sixshooters with bergmeister tires
Torqueboard 218 trucks
Randall split angle base plates.
Blue powdercoat on everything.
@Kellag, I have some neobox ordered, I’ll keep these on low settings until the neos arrive. @rusins I’m running the stock berg tubes with slime in them. Three rain I went this route was the bergs are softer and grip really good, plus less rolling resistance and a lower profile 145mm vs 160mm+ on the stock sixshooters. I wanted a pneumatic drop through low rider.
@rusins Lower profile in comparison to the stock tires on the sixshooters. The bergs and six shooter rims are the same size. @glyphiks I’ll post some up
It’ll hold a 12s8p nese! It’s made from fiberglass.
I made 2, I plan on using the other one on a different build. Here it is next to a torqueboards 12s4p enclosure
Lol yeah that’s huge! Was it hard to get off the mould? The vertical sides make it look like getting it off the mold might have been a bit of a struggle!
Actually no, I use the trash bag method. Wrap your buck in a trash bag and heat shrink it to it. Clay where the buck meets the deck. It’ll pop right up