Sorry for reviving an old thread. Here the back story. My board decided to not turn on after 200-300 miles of use. It turned off on me mid ride after some bumps. I turned it back on and it rode for a bit until it turns off again and then it wouldn’t turn on.
I swapped around the physical on/off button with my other board to determined the button wasn’t the issue. Tonight I realized the unity bluetooth module had popped off and just laying there under the silicone cover. I reseated it and the Unity still won’t turn on, I pulled off the BT module and voila! The board was alive. So I plugged in an older Metr BT module I had, plugged the unity into a computer which I haven’t done in the past two build since Unity had that easy app setup which no longer works without that module
Here’s my n00b issue it’s been like two years since I’ve used the vesc tool. I had to update the unity FW and VESC Tool in order to configure the Unity again. Went through everything and everything seems to run fine
ERPM was at 100,000. Am still supposed to put that at 65,000?
Next issue, with the unity I don’t have canbus so there no master and slave setting right? I checked the setting with the METR app, read the esc’s setting and saw setting for vesc 1 AND vesc 2 and they had different numbers, should I worry? Is this normal?!
Oh and here’s the BT module port. Does something look burnt to you?
