How’s your clearance looking with the 175 tires?
And here I thought you were going for a board that could switched for speed to torque at a moments notice
1 Like
You thinking shaving the deck or extending the front?
1 Like
Extension first. I would not like to cut in to this board.
1 Like
Agreed. I have an odashi on order right now also, with the same plan of 3links and hoping to run 175s. Probably 150mm for tracking it and 175 for in the world stuff possibly.
He mocked up a deck with an extension here and seemed to get clearance. I think it’s doable. Looking forward to seeing what you come up with.
3 Likes
I’d been thinking the same. Has anyone built the odashi to power level 9000?
I’ll tell you what, ill switch this build to the strange red 44 redember that @DEEIF tried to get glass fritted.
I don’t want to cut on this board.
3 Likes
Hell no that’s the Redember 44 Sender screwed up and wouldn’t admit to it. Dude straight up fritted it without anyone asking and just shipped it to me saying that’s how it was and he couldn’t help…
1 Like
…I didn’t mean you did it. It will buff out. 
1 Like
All 8, 3s packs fit perfectly if you massage the shrink wrap. @tomiboi
I’m going to leave the front compartment open for snacks for now. Post your favorite candy, wrong answers only and I’ll do my best to outfit the compartment with it.
3 Likes
3 Musketeers
1 Like
1 Like
I have half the lipos, motors, and esc’s installed, taking up half the enclosure.
Wheel bite is significant. I also snapped off a usb c port on a unity. I wanted to cry.
I rode it around the block, carefully.
Still looking for a matching heat sink for the front.
Worst case, I’ll grab an mboards sink, unless someone knows of a source for a esk8.news universal sink or one with similar dimensions.
4 Likes
Flap disc on a grinder makes short work of removing frit.
That Odashi is a fuckin beeeaaasssst
1 Like
Clearance is fine. Smaller 165mm pneumatic tires, stretched even, bite the deck. I guess I get make an offset hardware plate to set the trucks farther out.
Edit: removed link 
If you using unity i can cut you a deal on one of these, not exactly matching, but can do it chep chep
3 Likes
It going to be really, really heavy if 4wd. 50lbs plus.
30ah of 12s lipos, large heat sinks, longer board, printed hubs are pretty heavy compared to mbs hubs. And there are the larger motors.
I’m going to get it buttoned up and tuned with gearing for 2wd and slowly work toward 4wd.
Thanks, but I need to get off the unity train and try a spintend or a maker-x HV set up.
1 Like
My plan is to use a front extension to get the tire clearance also. My deck ships this weeks so I’ll be able to start figuring that out once it’s here.
I’ll probably mock it up with a simple piece of aluminum or wood to figure out the distance needed and then I may have a piece CNCd or even made by send cut send for it.
Have you found an extension or are you making one?