oh yeah that works, beats the $9 shipping fee at aluminum spacer dot com. thanks!
2 Likes
No problem. I didnât realize that redz shipped bearing without spacers. So ended up having to look for those
36/16 gearing
320 belts currently but I need to motor to sit as far back as possible as show in the photo, what belt length would be a good estimate to get this fitment
Most use regular 608-2RS skate bearings but some use 6900 (Evolve) or 628 (@dickyho) bearings. The 628 are better bearings because the balls are bigger.
1 Like
Right here bruh 
https://www.amazon.com/Nimbus-Spacers-Washers-Skateboards-Longboards/dp/B081KSP3WD/ref=sr_1_22?th=1
Didnt realize that was your post. I saw this earlier and used it to check if I had everything with my build at DIYboards but now I guess Iâm scratching that and starting over haha. Its a good guide. Thanks
1 Like
https://www.bbman.com/belt-length-calculator/
Go here, and enter all your pertinent details: Belt pitch, pulley diameters, distance between pulleys.
2 Likes
so I need 12mm speed rings
10mm speed rings and spacers
know a qwik source?
1 Like
I thinksss I got some 12mm speedeezzz from
Here. https://www.havocspeed.com/product/fragola-999212-1-12mm-aluminum-crush-washer/
Got me 10mm speedeezzz from
Here https://www.ledakartn.com/index.php?main_page=product_info&products_id=586155
And spacers I think I had got from trampa at least 10mm onezzz
I should probs findz a place that seellz all in 1
2 Likes
Ainât nobody gots time to go to so many different sitesssâŚ
2 Likes
Oooofffff⌠wellls they gots some of Deeez. https://trampaboards.com/shim-spacer--bridges-the-tiny-gaps-between-bearings-on-10mm-axles--10-x-16-x-05mm--p-24602.html
1 Like
Ohhh shyyttt they gotz 12milliii
Too.
1 Like
Use a piece of rope and wrap it around
1 Like
Hereâs moar spacerz for yaaaa one of dem gotta work
2 Likes
Is it safe to run VESC 4.12 in a 4s battery configuration?
Iâve seen the thread on how to make a loop key so I understand that part but how do you do it with a unity if you remove the switch does it instantly power on when plugged into a battery and is it fine to have xt60 on the battery and unity and then xt90 for the loop key
1 Like
It will most likely work but the power output will be limited to ~750W (based on 50A continuous for the 4.12 hw).
If you have the possibility go for a minimum of 6S or 8S, this will give you the same amount of power with less strain (lower currents) on the VESC.
1 Like
Thanks. Well I think current wonât be an issue since this is for my 6 years old kid. He not more than 15kg I think. I would like to go as light as possible, I would make acceleration curve really slow so he wonât get hurtâŚ
Also range is not an issue, everything more than 5km is more than enough.
1 Like