Thank you, bro.
This was the answer i was looking for.
never heard about that before.
Thank you for telling me.
Where is a good place to buy a hobby wing esc for belt setup?
ownboard / wowgo / backfire…etc basically those chinese brand that sells belt drive esk8.
fyi, if u want standby mode, try to email wowgo and ask them if u can buy the AT2 esc instead, that one has standby mode by default, just like exway (exway doesn’t sell esc alone, don’t bother trying)
How do I know what other tubes/tires will fit on my Torqueboards AT hubs?
Am i better off just buying new hubs if I want other/bigger tires?
There are “8x2” hubs
- MBS
- Trampa
- summate
- 3DS
- TorqueBoards
- Metroboard
- Evolve
And then there are “6x2” hubs
- Bergmeister
- Psychotiller
Tires are usually compatible within those groups but never outside
That thread is a wiki, you should add that to it
possible, but only if they were made for lingyi esc.
iirc, there are 3 versions of remotes that currently works with lingyi esc
Pretty much, no. It’s not.
I can personally verify there are 2 viable remotes, one is the small 3 speed shown in the picture and other other is the bigger 4 speed that looks like a vx1 with the finger hole
Is there any pneumatic hub/rim that fits the normal skateboard axle length? (2 bearings + 10mm spacers + 2 speed rings)
Specifically, the BN270 hangers with the only option of stepped axle
I am having 2 issues with my Flipsky VX1
- I always have to do the pairing again after powering off both the board and remote for a few minutes.
- My acceleration is really chunky with brake spikes in between
Metr log: https://metr.at/r/CUba5
Video: https://www.youtube.com/watch?v=UzbewzYELGw&feature=youtu.be
it would be really good if you could just switch say remotes to try to isolate the issue
I had another remote and that was the feather remote and it had real cutouts no spikes in accel but almost “killing” me cutouts.
I thought vx1 is the safest bet…
The only difference I know between those two is, that I used PPM on the feather and uart on the vx1
Have you tried opening the remote to see if maybe one of the potentiometer wires has a bad connection or anything like that?
Have you considered that it might be your esc?
Will do that asap
I dont think the escapes are broken, because the issues differ from remote to remote… feather is known for cutouts and the vx1 behaves different.