How do you bypass a common port BMS?
looks good. one thing I’d suggest is adding 2 extra screws for each segment that way if you loose a screw is doesn’t instantly separate from the board. might also be a good idea to make yourself some tpu washers to sit in-between the screw and the enclosure. I did this for my petg enclosure and its lasted my like 6 months.
3 Likes
Thanks man!
1 Like
Yes it can. 
You can. Heat and a wire brush is quite effective.
It can if you heat it too much, yes.
Loctite recommends methylene chloride (also known as dichloromethane or DCM). Acetone works too, but slower.
3 Likes
1 Like
So LED+ and - go to 5V and GND, and the 2 momentary pins go to GND and Power Switch pins? if that’s what you’re saying, I tried that. I also tried using a latching switch with the setup suggested in OPTION 1 from manual and no dice… @Trampa could you prease assist?
That’s how I understand it would work, if it doesn’t work, time to ask Frank.
1 Like
Can someone tell me what type of specific connector that is on the end of a flipsky 6374 motor? Mine got damaged somehow and I need to get a new one.
Any recommendations for real short motor mounts?
Evo 40 with boosted ss enclosure, seeing if I can fit motors under the board without putting this thing up on risers and changing angles. I’ve got some BKB and also TB V4? mounts and they hit the enclosure, does anyone make a really short motor mount?
JST-ZH 6pin 1.5mm pitch
2 Likes
the shortest i know is either the bkb mount or the OG enertion mount, they both use 265 belt iirc. for even shorter, u probably have to look at those chinese prebuilt board, i’ve seen some uses 255 belt, so they should be slightly shorter
Hi,
are there any solid choices for E-MTB builds except from a Trampa or MBS with E-TOXX parts?
Thanks!
1 Like
That is correct.
cool, I’ll see if I can track something that uses a 255 belt, or less, thanks!
Which is correct? The manual does not specify momentary or latching But I believe I read somewhere that you said it needs to be momentary. If that’s the case each of the momentary pins should go to power switch, and ground. Correct? @Trampa
Edit: I don’t think it matters, but this is a single Vesc operation.
Welcome! Apart from those there are also Moon drives, and Apex Airs and Luna trucks.
3 Likes
Is LLT good at resending BMSs? I ordered a Liion bms and got a lifepo4 one instead:
And I don’t believe these are compatible with liion
1 Like
Did anyone of you experience vibrations with the Meepo hubs when going fast? Starting at around 40-45kmh ?
1 Like
nope, all good for me.