I was running a flipsky 5065 270kv motor on 8s and the average speed was 26kmph
km/h
gg
26,000mph damn you fast boi!
3 Likes
kilomiles exist?
2 Likes
Anybody can tell me which belt length I need if I want to use tb 50xx motor mounts
with 36/15T gearing?
I do not have the mounts yet, so I can’t measure by my own unfortunately.
Length of truck center to motor shaft center would also be enough. The rest I could calculate by my own 
Edit: I see @torqueboards is online 
Maybe you got the answer for me here?
Did anyone ever had this issue with his OS DAVEGA / Flipsky davega:
When connected to the VESC, the display just shows a bunch of “00.0” placeholders, the red dot on the top is red for like 1 second, then flickers shortly, then red for 1 sec again.
Buttons dont work too
@janpom
Anything that causes this?
Using two Flispky 4.12
Voltage is stable at 5.15V
In the schematic RX - > TX and TX -> RX (logical)
But on the pcb it turns out RX goes to RX and TX to TX… Or they just labeled it for the assembly man…
Should I try to swap RX and TX, or is this unlikely to solve it or maybe even could damage the vesc?
It’s not really possible that they sell a product where you have to swap wires around though…
Whats the issue here?
noob shamans–
need help over here confirming I’m not crazy for suspecting a BMS issue.
1 Like
Probably too new VESC FW. I think only up to v3.60 is supported.
1 Like
I used JB Weld Wood for a similar task and it held up well, even though the deck has a fair amount of flex. Also, it was easy to sand
What is the best way to discharge a battery without using it? It’s veen raining constantly and will continue the next days with no change of riding.
1 Like
Flip the board upside down and throttle it for a while?
is there a way to get that outside of the usa?
I am not sure about international availability. You may want to look for “wood putty” at your hardware or home improvement store. Something epoxy-based should do the trick. @Movation suggested Miliput epoxy putty and that sounds like another solid option.
That’s minimal reduction. It would take several hours to get somewhere.
I would make use of metr discharge feature but i don’t have temp sensors.
1 Like
Didn’t take me too long but you could also just ride around in circles 
1 Like
So I’m a complete noob to this hobby. I’m a highschooler looking to build my own electric longboard, since I’ve built an fpv drone. I have two questions. I was going to build a dual belt drive with flipsky 6355 190kv motors, but I’m not sure if those are any good or reliable. I’m trying to stay on the cheap end, since I do not have a lot of money to spend. Also I’m looking to get a 10s2p battery at an affordable price, but it seems that I can’t find one that is cheap or legit. Any help would be appreciated.
2 Likes
I would buy these over Flipsky: https://diyelectricskateboard.com/products/electric-skateboard-motor-6355-190kv
For a budget-oriented 10s2P, you’re better off sourcing from Meepo, Ownboard or Wowgo, since they offer free shipping. Get the best cell you can afford.
3 Likes
Noobish Question, If I bypass the Switch on the Unity, do I lose Roll to Start and Shutdown after X capabilities?