Ok, ok .
The Flux was a bit more work to harvest.
Luckily I got some help.
Next I ran into a bit of a bump…
I was not sure how to pull the pinion away from the motor.
I banged my head on the table for a while before I realized I could drive bolts past the plate to push on to the motor.
And cool. that started moving it.
And here is where I got stupid.
Pay attention kids.
Don’t be like this.
It was barely moving up so I get long ass bolts and the power drill and start bumping it up.
And off course I break a bolt and can’t get it out.
Fuck a duck…
So one of the holes is blocked now.
It may be possible for me to orient the plate in a way that it does not matter…
Wish me luck.
On the second drive I used shorter bolts and took my time and it went smoothly.
I have figured out better ways to do things and try to me more careful and such and such…
But I really am still impatient and hasty and have to just keep it moving all the time.
And it leads to screwing things up…
But I nothing major today so far. Just a bit of time lost.
I have all the parts separated and can get back to reassembly.
So that’s exciting stuff.
I have 3 boards to put together now.
I’m doing the Gravel Boi later on because there is more happening there.
I’m gonna call it a night.
But I wonder what will be next. The easier straight forward Khymera.
Or the more exciting Flux.
I’m really pumped about the Flux and I really hope this round of changes ends up getting it to a really good state.