M1 Gear Drives and TB 110s

[b264]

If you do hammer, and I’m not recommending to do it or not to do it – here is a guide for a different piece of hardware

How to remove/install a 3D Servisas kegel wheel pulley [SRO]

To install the 3D Servisas kegel pulley: Put the pulley in the wheel Set the pulley on a hard surface Put a wood block on top of the wheel Hit the wood block hard {centered over the wheel hub} [20190415_185637] ​ To remove the 3D Servisas kegel pulley: Set the wheel like this with a bolt in one of the holes [20190415_185739] Hit the bolt hard a few times until it moves slightly. Then put the bolt on the other side and hit it hard a few times until it moves. Then go back to the first …

Maybe it can give you some ideas.