hello fellas!
well, it’s been a good two weeks.
I’ve finished just before our autumn ride.
I’ve had some problems integrating all the parts together, so I’m currently just with davega (ennoid apart)
22S is so far quite nice. and quiet it is. love the GD. the trucks and rims are so ballin. this finally looks like the “grownup” board.
running
abs max current 150A
motor/battery 100/-65A
hyst mode, reverse erpm 5000
sensored
25PSI pressure
the consumption is quite horrific - ~28Wh/km. I’ve been getting 23 on it when It was just on 12s. ~22 on previuous boards
so its about 40km (with slightly undercharged battery) at ~55kph. I’m still affraid to push it. I’d like to measure and test the powercurves experimentally, not with my health and body 
its a great board as is, but I wan’t to get to the finish line
- clean it - it should be also nice to look at
- find out what rattles inside - I suspect the spare xt90 to the battery
- connect the “always-on” part of the rear light
- possibly make better mount for the rear light
- make mount for front light
- connect ennoid and metrPro without corrupting stability
- make the charger more silent by swapping fans to two 120mm
