That boardnamics one is a really good mount 
surprisingly cheap too. I wanna see how cheap i can get this thing. The vesc is going to cost more than the entire board minus motor mounts 
im stupid ignore ^^
just realized i need a power switch, and my enclosure is made of metal yikes
now that i have most of it figured out, this is what im still looking for.
I realistically cant make a square hole in an alu enclosure
Dont have a dremel or a saw.
You only need a drill and a file. Or just a file and a nail.
Epoxy helps A LOT.
I only have a drill and a wood saw, but i need an excuse to get my dad to buy me a dremel. I luckily dont have to pay for tools.
Use a roto zip bit in your drill. Cuts aluminum perfect.
bump still looking for a mini vesc of some sort, preferably the lower amperage makerx/fsesc mini 4.xx
bump also expanding this to torqueboards ESC or mini fsesc.
bump ill take any single vesc actually. The one “rule” is that the max dimensions are 90x180x22. I dont really need a heatsink on it as my enclosure is just aluminum. I’ll use some thermal pads and hot glue to hold it down.
Hot glue could melt if it’s holding a heatsink down.
I had connectivity issues when my VX1 remote receiver was in a metal enclosure, so definitely be careful with that!
Yeah, I was gonna stick my antenna out of the enclosure with a teeny tiny hole.
Good point, I’ll find a way to adhere it down but I just need a very small vesc.
If small is your goal, MakerX are worth a look
Flipsky MiniFSESC 4.20 as well
I wouldn’t drive those past 25A batt max
my battery is a 10s1p of 30q, wouldn’t do that anyways